This is the solution to the premiers and first activity where you need to combine Linc Energy and save
money, for example.
So if you don't understand everything right now, it's not really a problem.
Just continue and everything would make more sense.
The following sections.
OK, one other important thing is that you can understand a little bit how things are working and then
will dive into much more details later.
And to be able to finish this activity first, make sure that you could correctly execute all of the
programs from the previous lessons.
All right.
And now let's start with the activity.
So I'm going to remove that comment in lines that we don't need anymore.
And so we need to blink an entity and also to use the same communication.
So what I'm going to do is to use PIN.
Mode with so 13 and output to initialize the energy, so to initiate the pin for the energy and then
say all that, begin with nine thousand six hundred.
So there is not really any other specific.
And for that program here, both institutions are different and don't need each other to work.
But what I'm going to do is to put first initialized the cellular communication.
All right.
Everything is set up now in the loop.
What we can do is to make the blink so digital, right, that in a.
And then we wait for so we need to operate on for two seconds, so I'm going to wait for two thousand
milliseconds and then digital, right, 13 we load.
And another delay of one cigarette this time, so 1000 milliseconds.
So with this, we should be able to see the energy bolt on for two seconds and then pulled off for one
cigarette.
And we also want to print something when we pull on the editing.
So let's see here we can but say Algate print L.N. with energy on.
And again, don't forget the SEMICON OK at the end of every instruction.
So we print energy and we pour on the energy, then we wait for two seconds and then we can print.
Any day of.
Before we pull out of the enemy and then we wait for one thing.
All right, so that is the complete code for this activity, not where I'm going to do this.
I'm going to verify.
So let's name it activity one safe.
You can see them campaigning great, so it's working now, let's make sure in all that we have, you
know, and the correct so the correct board and the correct spot we can upload to program.
I'm going to show up and say I'll monitor.
So you can see the energy blink on and off, and when we turned on the science monitor, also Prince
Endian and when the energy turns of the sand, little Prince Ali of.
All right, that's the end of this first activity.
Make sure that you are comfortable with what happened in this section before you continue.
And now let's see how to build your First Circuit.