Good morning, friends.
Today, we discussed about DataStore Programming Initiative.
So, first of all, we have to open a new website right now.
I'm using Intelligent Design.
This is my blog, Ramallo, or you can say this is my programming and this is my third panel of results.
So and let the data flow is from left to right.
But in another software like Matlab or C or C++, the data flow is from top to bottom.
So always like this.
Data operation, first I go to it, you can use any program like this, I'm reading a program.
As you see.
And in this this is my control and this is my, again, another control body, and
this one is.
Subducted.
You can be in this world is clean up where?
Again, you can clean up this, OK, so again or here I'm using the Wii.
And it is multiplied.
With the same venue.
And Heather.
I guess.
Indicative that this is the output of this program and this is the output of this program, so you can
use highlight execution to check the data flow.
So right now on the result window.
I brought some values like eight index and two in life.
And when I perform this operation, as you see the data flow.
Is from left to right, is not depend on the politician, like in this case, the output.
Of this subject depends on like I am reading this, where output of this letter is depends on the input
of this subject is depends on the output of this item.
Until this perform this operation, it will perform or it doesn't give the output.
And again, the output of this is depends on this subject.
So, again, when I run this value again, the floor is from here to here.
So in this, the data is always flawed from left to right.
It doesn't depend on the pollution of your note.
These dividers subject the multiplier are the notes.
OK, thank you.