Today.
I will tell you how to generate multiple analog signals using any USD 6009 card with the help of Python.
So over here in the previous video, I just tell you about the how you can generate analog signal using
a USB 6009 card for multiple signals.
You have to just copy this part.
And place it as you see over here with the next task.
I'm just starting a task or assigning the task over here.
Analog output.
I want to perform analog task and it is analog output as a voltage device.
One is selected, PIN is selected A0 zero analog output pin zero.
And in the my channel I just set 0 to 5 maximum volt.
And initially over here, let's say it is five volt and the variable name is five.
And I want to just also print this value.
So what I just so print
value.
I want to just check also.
And for another pin, I just change it a zero to a one because on the in the case of my USB 6009, only
two analog ports are there.
My channel in the range is again 0 to 5.
And over here the value variable name is value one, and the value for this variable is also five volt
or you can say five.
And also I want to just print this value.
In the code also.
So in case in this case the value is the variable is value one.
Okay, So save it.
Now you have to just run it.
And on the hardware part, I just connect the negative pin to the ground and positive pin to the A0
zero and in this case, A0 one positive pin a0 one is connected to the positive pin and ground blue
one is ground and it is connected to the ground.
So when you click on run button.
It will print five five.
As you see, both the LEDs goes high in this case.
And now I want to just change this value from 5 to 3 to check the brightness.
So again, save it and run it.
So now the brightness is less.
So again, I want to just change the value from 3 to 2.
Save it and run it.
Now the value is.
Brightness is very less and the value is two two.
Again, when I just put this value is five.
Now again, run it.
Brightness is high in this case.
As you see.
And when it is one because it is below the threshold value, both the value is one.
Let's run it.
Modalities goes low and when you change.
Alternatively, so one is five at the analog a0 zero.
I just write five and another I just write one.
In this case, only one goes high.
As you see.
And when I change the value, it is one and it is five.
Save it and run it.
So now it will generate signal according to my given condition.
So this is how you can generate multiple analog signals using an USB 6009 deck card.