Today, I will tell you how to interface infrared sensor with LabView using Ardino Neno so or here we
have Ardino Nano and I just made the connections.
So on.
The audio module will be have weak ground and one output.
So I just connect the output with the five pin and Bleckmann is my ground and that one is my VXI.
So as you see over here, when I put my hand in the front or on the front of this Allard's blink, it
will generate a signal.
And when you remove my hand, balladeers goes off on hold on hold.
So this is the indication that my module is working.
So I just go to the software part so you have to interface.
You are already nonono with Lendu from the tools maker hub line from where we are.
Then go, just go to the we walk over here, we have the tool box so fast, the same procedure Waupun
laws and in this case I have to just leave.
There is no signal.
So just this one.
This this connectedness, so here we have our computer that is complex and then we have to take the
borate, in this case it is nine six that zero.
This is the same borate in the case of Ardino also.
But in the case of Maiga, it is different.
So all here you have to just select the PIN number.
Right now, the PIN number has been number five and over here you have to just select the balloon.
So order here.
This is the balloon, Élodie.
To display the output of I have said this and I just use Willaura for continuous reading control and
then just go through the error handler.
The procedure is the same in all the cases.
Just you have to just check out the dataset of different sensors, like some sensors generate does signal
sometimes out of analog signals, sometimes have acquired analog signals, some sensors required, not
sensors that are like relay, some required signals, some required analog signal.
So according to that, you have to program.
So this is the program.
It is ready.
So when I say don't run button, as you see right now, then ladies off.
And when I hit on, when I place my hand.
So it is going off and over here again, daylilies goes on.
So when I remove my hand, LRAD goes off, on or on, off, on, off.
So this is how you can interface.
I came up with you.
Thank you.