Morning today, I will tell you how to interface Bieksa 11 11 center, which is temperature and humidity,
Bazerman used for temperature and humidity, Masamune using LabView know.
And so here we have three pins plus one means vxi negative for the ground and out.
In this case we have Kriol out.
So why does this still happen with this.
And over here.
This is my favorite.
And this is my ground.
So this is the hard part.
You just go to the software part or here you just go to a new vye as you see, and then just interface.
You already know Nannerl with view.
So just open Linux from where we are or here you have to select the family device type method of uploading
for no.
Next.
So it will take some time line somewhere.
Wizzard is uploading on already nonono as you see this is my already nonono and it might be one sensor
which is used for humidity and temperature.
Masumi.
So now after the uploading you just go to the software part or you can say software program.
In the Makower hub we have NBT interfacing sensor like our here.
Just go to the Linux Open Glos and over here in the center we have temperature and not this one.
It's Lineas you can just find find out the DSD now and sensor.
This is for BMB.
B Yes this is for re open.
And I just require the one sensor, so that is our hair, we have ultrasonic read.
The U.S.
In this case,
not this one.
OK, so I just open and read.
So these are the best VII's.
It says a dress.
Yeah, this.
This and over here you have the board,
that is the six, just saying it is a common stand because we are not interested in ending this.
So for continuous reward signal, I guess, put a value over here, get control, and over here you
can find out that temperature.
And over here tonight, OK?
And over here you have the PIN number, like in this case, what is the PIN number you can select go
here.
So this is how you can create a software program for DSB 11.
Thank you.