Good morning.
I will tell you how to interface with flame sensor, so here we have our flame sensor for Five-fold
is still on a low out and you can use any.
Then, like on Adolphine or so right now, are you just going to five or.
And signal.
To the kind of open.
Not open to the bin and the ground, so as you see or hear that they sensories.
Or here.
It is loose somewhere.
So when there is a signal that this will go, so you have to just go to that software bar and overhear
just a program for the flame sensor, like for fun clothes, and in this case, the three, so that
it is connected to the number five.
I just figured I'm going stand in this case.
Here is my PIN number.
And this is added to one simple pattern.
And in this case, the fact this and over here, they have to just.
CommVault, as you see, so our air rig, about eight, nine, six double XL and one video for Continuos
saluting the signal.
We had control and one led with the flame is present or not, just back this control you are right now,
the program is OK, so we'll just get a flame.
So appropriate, a flame I just used.
As you see, signalized generated.
And when I say you don't run, but run over here.
So right now, again,
I just get the flame first.
So as you see over here, I have a flame and it is going on, off, on, off, on, off.
So this is how you can interface flame sensor or you can detect any flame in your house using flames
and you can interface flame sensor with know with the help of you.
As you see, the program is very easy in this case.
Thank you.