Good morning.
Today, we discuss how to interface at that center, Cardinal Nannerl.
And the programming is done with the help of LabView, so over here we have our that same set, it has
three things.
One is ground, another one is VXI, and another one is signals.
So the black one is.
This one.
Right.
My name is Vicky and this is signal and the signal is back here to be defaulting.
So just go to the software part.
So in the software part you have to interface.
You already know Nannerl with LabView using the rules and make it up and then go to the toolbox.
And in this case, the sensor will generate the signal or you can see analog signals, you can Romick
remotely.
So right now I just use this signal.
Right.
So here this is my signal.
Source and over here, we have to select the pin and in this case, my penis.
And over here we go to value.
So for the value, I just go to the.
Classic and over here, we have classic bloody.
This is and this is my community, which will give the output of my center and I just use the value
for continuous Hrudey, you can use analog signal also analog read and is the lead.
OK, so I just a simple add up here and just create a constant and constant in this case.
All here.
This is my bowl and over here we have my.
Morning, that is nine six a.m..
So when you hit on the button, you are sensories underpays.
So when you touch and you see a below and you remove.
Hold on, hold on, hold on.
Hold on, hold.
So this is how you can interface that sensor with Ardino manual.
Thank you.