Good morning.
Today, I will tell you how to interface ultrasonic sensor with our international using LabView.
So over here we have a sonic sensor.
It is at CSIR 04.
And this we have four bolts or four pens.
One is VXI.
One is ground.
Another one is Grieger.
And another one is equal.
OK, or you can say signal.
So as you see, this is plus five ground is this one and this one.
This pen is these six which is connected with that regular pen.
And this is my karpin or you can say a signal.
So right now this is the part of the connection and this is the software part over here.
I just think there's still been five as my karpin signal, or you can say it, but there's still six.
And this is my Dupee cycle for that trigger pin and this is the pulse rate.
And over here we have the best bands in Centimeter and Ingeus.
So here we have the software program.
So this is the program how you can create B, how you can interface ultrasonic sensor with LabView using
Makaha.
So when I hit on one button, as you see the data.
So right now it is changing.
So I just put the sonic sensor over here.
And right now the distance, as you see it is around 12 centimeter.
Then it is nearly five centimeter, one centimeter.
So as you see, the data is also updated as my hand is moving away or towards the ultrasonic sensor.
So this is how you can interface.
I already know.
You know, not you already know NENO with ultrasonic sensor.
Thank you.