Today, I will tell you how to interface infrared sensor, or you can say either sensor with a buzzer
with the help of Ardino makeup using LabView.
So over here I have a Iaat sensor.
So this is the transmitter benot.
Expen.
Or this is the transmitter.
And this is the receiver.
This is the optics receiver, Ben AICS or transmitter.
OK.
And over here we have the right one is VXI black, one is brown and this one is our signal.
And over here, this is the flavor of the week.
This is the ground.
And this is my signal of a sensor that is connected to analog band aid.
And we have a buzzer and the buzzer.
Both beeping It's connected to a number 13 and it's connected to Brown.
So just go to the software part over here.
Just first, you have to go to Tools Maker Hub where we are.
Just select your board next, then select your board.
Right now, Mike on board is going say one then next.
Right now, interfacing fire is burning into the Ardino make, as you see.
So over here, the interfacing file is successfully burned.
Just finish it and go to the program.
Go to the Ardino Maker Hub tool box.
Just locate.
Do you have to first open, then close and in between, you know, to read and write.
Right now we have two Anello read.
So we're here.
This is the analog read.
Right now I'm using the analog signal to read the output of Iaat sensor and just write
our digital signal.
So connected.
As you see, does take simple air handler.
So over here, you have to select the bin as my pen is analog bin is eight and that they still been
in this case is in number 13.
And over here, we have to create a signal.
So over here, we got the Anello warpage.
So I Despierta indicator for that.
So there is my meter and the range is Solange's Five-fold, as you see, and I just get a visible digital
display and then just create a while for continuous reading of the signal.
And over here I just got this value and I just created logic.
So when the value is greater than some particular value in that case, it will create a true signal.
And that signal goes to my buzzer from this survey still.
Right.
And over here, I just created control and disk control.
Value in the start is OK.
So I guess I don't run button.
As you see right now, the value is zero.
So then I put my hand in front of Ardino Mega.
There is again some error in the program because in this case I am not selecting any component.
So you have to just create a constant for the computer.
So while creating these projects, I also discuss with you there are some errors in creating program,
so you have to carefully, carefully handle these areas like this.
So I again, don't run button, as you see.
So then I.
As you see the value, they went overboard then, I might add, the range is high, as you see right
now, all these little.
I thought this is my range for this year, and so you can change this range using this potential medium.
So when I raise my hand and go, this is again three point four, and you can place a delay for continuous
monitoring also.
So I put my hand over here like that.
And is this because I remove my hand
so it takes no signal right now.
I just stop this and I just create a delay.
So right now my hand is far away from this eye sensor.
So I just again run when I put my hand in front of this.
You've got some value.
That is a plain old.
And then I gave him all this, now put his zettl, OK, so this is how you can this is how you can fake
how you can take analog signal or read analog signal and dendrite.
Are they still setting up?
Thank you.