Today, I will tell you how you can acquire a signal or how you can acquire audio signal using any Mannick
for that purpose, I mean, just connecting my microphone to the audio input board, as you see.
And in the software part, I get to go to my express and over here I have input in this.
I have to acquire sound
and I just play OK.
And for continuous signal, I just get control for that.
For both you for audio signal, you may skip you.
And I might also
because you are there is installed hardware drivers or is also also available on your PC.
So in this case I just connect to my e-mail from chart and when I don't run, but then I see there is
a signal and when I play hello, hello, hello, hello, hello.
There is a signal.
And when I pause my audio, in that case there is no signal.
You can check the amplitude.
You can check the amplitude right now.
I am just updating the chart.
So in that case, otherwise skating is off and over here.
The amplitude is like five, apparently to be five and lower amplitude is minus five.
So when I had only one more done in that case,
there is a straight line.
And when I my voice is there, in that case, some signal there.
Hello.
Hello, hello.
Like this you can acquire a signal using let you.
Thank you.