So today, I will tell you how to acquire analog signal using and I might.
So for that purpose,
I directly go to and I mix I at here.
This is my lab bill 2015 BURZAN so I can create a channel and then I have to start the task and then
I have to stop the task and I have to clear the task.
And to acquire the signal, I have to read the signal and in this case, I have to read.
So over here I have to select a channel for that.
I think I am creating a constant.
And in this, I have to select which using which channel, I have to acquire the signal right now I'm
using a zero, so I am selecting a zero.
You have to connect your task and error.
This is your task and this is your error.
Then for continuous read, I have to place a while loop over the radio signal like this, so protesters
are created for this then or this, I create a control and this is my data.
So in the front panel, I'm just
taking a meter,
which shows me the output.
And I directly connect this and or continuous read.
I am placing a delay function also.
And in this, I put a hundred milliseconds, OK, and I'm also taking a Pullen button, because on the
hardware side I'm using a sensor which can detect a load, which can detect the object.
So I know that the output of the sensor is.
Great, then.
Three, Paul.
So poor in the comparison.
Over here in America, here is the comparison, and this is the creator, I directly connect this balloon
to this creator and output and this output is greater than two point five.
It will blow our objectives, Detective.
OK, so for better handling, I just.
A simple added handler also, and this is my vye.
To get the analog data, so on the hardware side, as you see.
This is my my deck and this is my five-fold for this year center and over here I connect differentially
analog input.
In that case, the zero negative and ground of analog input is directly connected.
And this is my ground wire and this is my input signal from the air of as I place my hand or this as
you see the light below.
So this is working and this working.
We can also show we're using back using LabView.
So when I hit on one button.
And as you see, objects object detected, an object detected, an object detected.
So this is the program for either sensor or for analog data, because the output of this sensor is still
an analog mode because it will create a signal when an object is detected and the output of this is
around three point six volts or three point three word.
So this is the program for analog input detection.
Using my back in this case, I'm using a sensor as analog input source.
So thank you.