Today, I will tell you how you can operate a relay using and I mean you can operate use your relay
module using analog outport or using these bolts off and I my neck.
So here is my relay.
And on this relay, there are three bolts.
One is basically another one is ground and one is input or signal board.
So I directly connect to the plus firewall of and I Mitic ground to unallowed ground and the input signal
to the EU zero support in this case.
So right now I'm creating a program to break this relay support for that purpose.
I basically create a channel in this case, the analog output that I'm selecting, analog output voltage.
Then the board and the board is IL zero, then I have to start the task
after that.
In this case, I am creating a signal.
So I just
write a signal and then stop,
then clear.
And I require one function also to handle the error, simple error hindle and for continuous signal
I just create a value loophole there.
So this is the program and here I have to input the value which I have to generate using and I might
say so.
In the worst case, I am just taking a vertical slider and he is Five-fold.
I just put this value here and connect it to data input and I'm pressing control.
You will minimize my program and when I put on one button as I increase the value and the threshold
value reached the relay because as you see in the video.
So then I
you can check the Greenly On-Off and the sound is also generated in this case, the relays switching
between normally open and normally closed.
So the radius around four point three point nine, Morad, as you see.
So now I am just stop.
I just stopped the program.
And to create a push button situation,
I just big case Dutcher there.
This is the case structure.
I just connect this case structure.
This is my guest.
I am just increasing the size so you can see.
So this is the case structure, the boolean, which I'm naming it switch.
In this case, I just creating a constant BBR floating value.
You can place numerical.
So you have to connect this to this.
In this case, in the true case, I am placing four point three hold and in the case I just putting
the value zone.
So this is the problem.
And when I don't run.
But as you see when I switch on the button, the relay is also switching.
So this is the problem.
How you can use relay.
Using night, my deck.
Thank you.