Hello and welcome back.
So here in this tutorial, we will learn how to add a sturdy set up your simulation and compute your
result.
So before we start, let me just change the value of your barometer.
So I'm going to change the value of inductor to four hundred because I think we need to add some higher
values to see the result properly.
The nature will be same, but for her inductance, uh, the potential drop would be higher.
So, OK, so now we are inside the study, uh, as it was in our old model.
So click on Time Dependent study.
Now select the study two milliseconds and in the range just type range, 10 comma zero point one, comma
50.
So basically the simulation will run from ten millisecond in the step of zero point one millisecond
to 15 millisecond.
OK, now what you need to do is click on study one, then go on to study.
The click on biometric chip.
When you click on biometrics sweep, you will have the parametric sweep tab in your study note.
Now in the biometrics zip, click on the plus and you will see that your barometer, if you will be
here in the perimeter, you can type in the number, basically the frequency which you want to study.
So I will just manually write 100, 200, 250, 300, 350 and 400, let's say.
So these are the frequency values, which are the simulation will run and it will run for this time
range.
So to run the simulation, click on study and then click on compute.
When you click on compute, the simulation will start running and you will see there will be a convergent
plot.
It might take a few seconds to solve and he will have your plots.
So in our next tutorial will go to the results and see what results we are getting.
Thanks for watching and we will be back in our next lecture.
Take care.