Hello.
In this tutorial, we will continue to build our communication program already we adopt our settings
then.
Now I will insert the role here.
Then they will do one more thing.
I will put a timer to start communication arrest for under the need for communication.
When you open the policy or when you open the energy of your electrical board and the drives is going
to be open after one or two seconds.
OK.
And that moment, if your pulse is starts to communication, suddenly after zero point four second from
here, you can see suddenly it will give an communication error.
How can we protect it, protect our communication?
And how can we prevent it?
And 1000 always-on.
OK, I will start the timer timer, for example.
Let's say 60.
OK, how many seconds?
Let's say three seconds.
This is the first thing.
And then we can insert a one more or tomorrow to here.
And if timer is activated, LDP timer 60.
OK, run the rising edge.
We are going to set to beat and one thousand three hundred and fifty.
And also one more thing.
Said and one thousand three hundred fifty four.
OK, then you will see enable the function of the PLC selling and enable ultramodern kirschling.
What is this?
According to our settings, OK, this two bit is going to communicate the PLCC communication.
OK.
And I will go on line again to my place here.
And this program is going to be standard to see.
And I will say yes.
I will say yes.
Then it is standard, OK.
Let's wait a little bit more after three seconds then, OK?
And now something is changed.
If I go to communicate.
I want to show it to you also.
And let's start.
Then you will see now arrest 232 is active, OK?
But that word four hundred and eight to five communication was active, but when it is stopped, normally
it is in the wrong condition.
And I believe it is not detected 350.
So these are all receptive.
So we can activate these to so on and so on.
And then you will see arrest for on an eight to five flight is flushing out, OK.
But we need to go to here.
I will show it to you once more.
There is a timeout time.
OK, now focused here.
It is searching arrest for under an eight to five communication, but it is not detecting the thief
because of why the parameters of the VFO is not up.
OK, so I will stop this time for this tutorial into next tutorial.
We will continue with the the communication parameters of the VDT.
And also, we will continue to write PLCC program of the vessel for the communication ideas for on eight
five four US communication of the Virgin PLCC.
And I am finished for Restoril.
See you.
Internet2, Toro.