Hello and welcome.
Now, most of you know that e-sport has built in touch sensors, so you will take the readings from
three touch sensors from our ESB board and to do that, we have a touch sensor on Pins two, four and
15.
So go to the lube.
And here you can simply write in your request.
And a sort of sense of value, one you can say blessed with.
Dutch
read.
Which is basically.
A function that would take the pin number for the touch sensor.
So this is our first touch sensor.
And for value tool, we will tie Dutch read,
the second sensor is up general purpose input output pin number for the third sensor watches touch read
number 15.
Now let's upload the code again.
We will make sure that our web page will play the reading from these three Dutch sensors.
You can replace this with any other sensor, so there is no limit here.
You can add more sensors.
You can add more items to the table.
It's up to you now.
There's an opening for.
OK, let's touch the ball again.
Click upload again and wait a few seconds until the code is compiled and uploaded to our USP board.
And let's get our page ready, as you can see.
This is our page, the request page.
And it did take a lot of values, as you can see here.
Now, the sort of value and value tool and value three.
We will get.
The essential values.
So it will be more useful to get of reading here now than uploading.
Let's refresh the page.
OK?
As you can see now we have censors reading.
As you can see, this is the first touch since all of this is the second one, and this is the third
one.
Every 30 seconds, we will get nuisance or readings.
I will refresh the page.
I can see now we have new readings.
You can add other sensors.
You can change this to be too ambitious since your
humidity sensor or any other type of sensors.
Sky is the limit here.
Again, all of the codes and everything will be attached to the course material.
If you have any questions regarding anything, I'm here to help you.
Thanks for watching.
This is Ashraf from educational engineering team.