Welcome the module 8.3 programming the base is to bored jump per 3 when you're getting ready to program
the bases to board make sure the JP 3 is connected to PC using adept.
The next step is to plug the bases to board into your computer.
Your computer should start to go ahead and start downloading the firmware files associated with the
bases to board.
Once the device drivers drivers have installed successfully open up the software application and then
click on the Initialize change button.
The Deaf software should recognize the FPGA MP rom devices located on the basis to guard the depth software.
Here's a screenshot of the DEP software application.
You should see something similar to this.
However if you have a different board instead of the bases to board and it is supported by the Adept
software you should see it located here.
Click on the browse button and navigate to the VISC file we created in Xilinx ISC.
If you see a warning about the startup clock click yes and click on the program button.
The bases board should now be programmed.
You've just finished a module 8.3 programming.
Your base is too bored.
Here's a summary of everything.
We went over.
You first need to create a file in a Xilinx IAC.
Adept is used only to program your development board.